OPTO 22 - ODC5R _ Reed Relay Output, 5 VDC Logic

Quick Specs:

Reed Relay Output
5 VDC Logic

The ODC5R is a Form A mechanical relay I/O module. This module was designed for a low-voltage DC load that that is purely resistive (no inrush current).

Typical applications for these modules include analog signal and communication line multiplexing. Because of their low 10 VA rating, these modules are not recommended for inductive or capacitive loads (even very small loads) because the inrush current is likely to exceed the 10 VA rating.

IMPORTANT: Applications using 120 VAC are typically NOT suited to this module. If you are considering using this module for any application other than low-voltage purely resistive loads, see the detailed notes and rating curve in the data sheet, and call Pre-sales Engineering for specific guidance.

Specifications:

Item	Description
Contact type	Form A SPST-normally open	NOTE: The application of the dry contact module must not exceed 10 VA under steady-state or momentary in-rush conditions. For voltages at or below 20 volts, the current limit is 0.5 amps. For voltages above 20 volts, the maximum allowable current is determined by the following equation: Maximum Current = 10 VA / Voltage
Line Voltage - Range	0 - 100 VDC 0 - 130 VAC (see Note)
Current Rating	0.5 Amps Switching (see Note)
Contact Rating	10 VA (see Note)
Switching current	0.5 amperes maximum¹
Carry current	1.5 amps maximum
Contact on-resistance	200 milliohms
Turn-on time	500 microseconds
Turn-off time	500 microseconds
Contact bounce	250 microseconds
Mechanical life	5 x 10⁶ cycles
Logic voltage range	4.8 - 6 volts
Logic droupout voltage	0.8 volts
Logic input current @ Normal logic voltage	14 milliamperes
Isolation voltage Input-to-output	1500 VDC
Temperature Operating	0 to 70 °C

Current Limit at Key Voltages
V	mA
5	500
12	500
24	416
100¹	100
120	83
130²	76
1. Maximum DC voltage is 100 VDC
2. Maximum AC voltage is 130 VAC

Write a Review