OPTO 22 - G4ODC5R5 _ G4 Reed Relay Output, 5 VDC logic, normally closed
Write a Review
OPTO 22
OPTO 22 - G4ODC5R5 _ G4 Reed Relay Output, 5 VDC logic, normally closed
- Brand
- OPTO 22
- SKU:
- G4ODC5R5
OPTO 22 - G4ODC5R5 _ G4 Reed Relay Output, 5 VDC logic, normally closed
Quick Specs:
- G4 Reed Relay Output
- 5 VDC logic
- normally closed
The G4ODC5R5 is a low-contact-resistance DC output. It is a single-pole, single-throw, normally closed mechanical relay (Form A, SPST-NC). It was designed for a low-voltage DC load that is purely resistive (no inrush current).
Typical applications for these modules include analog signal and communication line multiplexing. Because of their low 10 VA rating, these modules are not recommended for inductive or capacitive loads (even very small loads) because the inrush current is likely to exceed the 10 VA rating.
IMPORTANT: Applications using 120 VAC are typically NOT suited to this module. If you are considering using this module for any application other than low-voltage purely resistive loads, see the detailed notes and rating curve in the data sheet, and call Pre-sales Engineering for specific guidance.
If you need a Factory Mutual approved version of this module, see the G4ODC5R5FM.
Specifications:
|
| Units | G4ODC5R | G4ODC5R5 |
|
| Contact form |
| Form A SPST | Form B SPST | NOTE: The application of the dry contact module must not exceed 10 VA under steady-state or momentary in-rush conditions. For voltages at or below 20 volts, the current limit is 0.5 amps. For voltages above 20 volts, the maximum allowable current is determined by the following equation: Maximum Current = |
| Normal position |
| Open | Closed | |
| Contact rating | VA | 10 | 10 | |
| Maximum switching voltage | VDC | 100 | 100 | |
| VAC | 130 | 130 | ||
| Maximum switching current | A | 0.5 (see Note) | 0.5 (see Note) | |
| Contact resistance | Milliohms | 200 | 200 | |
| Turn-on time | microseconds | 500 | 500 | |
| Turn-off time | microseconds | 500 | 500 | |
| Contact bounce | microseconds | 250 | 250 | |
| Mechanical life | cycles | 5 million | 5 million | |
| Logic voltage range | VDC | 4.8 - 6 | 4.8 - 6 | |
| Logic OFF voltage range | VDC | 0.0 - 0.8 | 0.0 - 0.8 | |
| Logic ON voltage range | VDC | 3.8 - 6 | 3.8 - 6 | |
| Indeterminate range | VDC | 0.8 - 3.8 | 0.8 - 3.8 | |
| Logic input current at | milliamps | 14 | 14 | |
| Isolation voltage (transient) | VDC | 1,500 | 1,500 | |
| Ambient temperature: | °C | 0 to 70 | 0 to 70 | |
| *Part numbers ending in FM are Factory Mutual approved. | ||||
0 Reviews Hide Reviews Show Reviews
OPTO 22
OPTO 22 - G4ODC5R _ G4 Reed Relay Output, 5 VDC logic, normally open
OPTO 22
OPTO 22 - ODC5R _ Reed Relay Output, 5 VDC Logic
OPTO 22
OPTO 22 - G4OAC5A5 _ G4 AC Output, 24-280 VAC, 5 VDC Logic, Normally Closed
OPTO 22
OPTO 22 - G4ODC5 _ G4 DC Output 5-60 VDC, 5 VDC Logic
OPTO 22
OPTO 22 - G4ODC5A _ G4 DC Output 5-200 VDC, 5 VDC Logic
OPTO 22
OPTO 22 - G4OAC5A5FM _ G4 AC Output 24-280 VAC, 5 VDC Logic, Normally Closed, Factory Mutual Approved
OPTO 22
OPTO 22 - G4ODC24A _ G4 DC Output 5-200 VDC, 24 VDC Logic
OPTO 22
OPTO 22 - G4ODC15 _ G4 DC Output 5-60 VDC, 15 VDC Logic
OPTO 22